Spud Wrench

Posted by admin

Spud Wrench

A leaky toilet can lead to other important issues, as you can damage the floor and under the floor. More serious problems can also damage ceilings and shots below. The losses may be caused flush valve or fill valve. However, sometimes, can also be caused due to hairline cracks in the tank places.

These are very serious problems, and in these cases, it may be necessary to replace the tank or possibly even the entire toilet. We tried to explore some possible reasons for the leaks, and the procedure to solve the problem. In order to discover the reasons for leaks, first tighten all connections.
Dry everything with a towel and then carefully examine the source of leaks. Once you have determined the source, you can move forward and resolve the problem by using the following steps.

Loose Nuts under Tanks
Tools Required:
Flathead screwdriver
Adjustable wrench

Procedure
1. Using the screwdriver flat, hold the bolt steady.
2nd At the same time, tighten the nuts on the bottom of the tank with the key control.
3rd Check if the water still leaks. If not, that is great. If so, follow the steps below.
4th Holding the bolt constant (as in step a) using the key control, removing the fruit a shell, and change the washer with the correct size new washer for the bolt.

If water is leaking at the Fill Valve
Tools Required:
Wrench

Procedure
1. Turn off the water supply for the bathroom.
2nd Drain the tank by flushing it
3rd Using a wrench, disconnect the supply pipe-coupling nut.
4th Remove the mounting nut of the filling valve.
5th Lift the filling valve
6. Clean his seal and washer
7th Consider carefully if it is damaged or dehydrated. If so, there is no other option but to replace it.
8th Keep the valve upright and carefully place in the center of the hole.
9th Tighten the mounting nut. Be sure not to overtighten, as you may break the porcelain.
10th Reconnect the supply of pipes
11th Turn the water supply for the bathroom
12th If the problem persists, tighten the mounting nut un po 'di more.

If water is leaking at the valve
Tools
Large standard screwdriver
Socket Wrench
Spud Wrench
Soapy sponge

Procedure
1. Follow the steps 1-3, as discussed previously
2nd Remove the mounting bolts of the tanks. For this, you can use a standard large screwdriver on the bolt and a socket wrench on the nut.
3rd Put the container upside down.
4th Pull or twist the rubber washer Spud.
5th Unscrew the lock nut large valve using a key Spud.
6. Put the tank aside. However, make sure that you insert on a bath mat or similar padding. In this way, You can protect both the floor and the tank.
7th Remove the valve.
8th Remove the cone of the bevelled washer valve.
9th If you are in poor condition, replaces them. If not, just use a soapy sponge and wipe them.
10th Reinstall the reservoir, as discussed above. However, make sure that when you tighten the bolt, you have someone to hold and lead.
11th Remember, the side edge of the cone washer faces the inside of the tank, while the beveled side of the washer must Spud facing the bowl.

Then, follow the simple steps above and you can do yourself. However, make sure you have the necessary plumbing tools at your disposal.