Posted by admin
Many rural homes depend on a water well to provide their families with a safe and clean source of water for drinking, food preparation and for washing. Unfortunately, many people discover when their water and uncontaminated became contaminated with bacteria. This can occur when septic beds are placed too close to the good, or when the water surface is allowed to enter the well cap.
At this point the majority of buildings look to modern technology to get rid of bacterial contamination in their behalf. For many, the home is a top choice Ultraviolet (UV) water purification device. UV system installation is very simple and requires only limited plumbing and technical experts.
The first step to installing a UV system is to determine where it should go. Ideally, a model should be chosen that is able to treat the water for the whole house. A model that will treat 10 liters per minute is usually sufficient. The UV system is plumbed on the main line of water and should be the last piece of equipment for water purification, before the water is conveyed to the rest of the house. Thus, if a water softener or iron filter is present, the system should sit after the ultraviolet softening. It 'also important to note that the 5 micron sediment filter must be installed before all UV systems. The typical order of equipment for the home with a well is: well pump, pressure tank, water softeners, 5 microns, UV filter system, tap.
From an installation point of view, a system of UV light is really just a glorious piece of threaded pipe. Most of household will have 3 / 4 "NPT nipples. It's better to plumb the UV system with copper. UV Light plastic break down quickly to the point of failure so it is not advisable for the sound system with UV PVC or flexible plastic tubing. Many professional installers will use the trade unions so that the UV system can be easily removed if the maintenance is necessary for the future. When connecting unions or other accessories be sure to use three or four passes of teflon tape to ensure good required. A paint stucco can also be used with equally successful results. Make sure that the system is installed ultraviolet light and to allow sufficient clearance UV lamp to be inserted and removed. UV lamps should be replaced every year.
UV systems require standard 120V AC power. It 'always best to use a switch circuit fault on the ground (GFCI) outlet when the power of a device that has been exposed to water. E 'ideal to locate the power receptacle line above the water. In this way the possible leak of information, or when you change the UV lamp, the water can not run down the power cord to an outlet. If you live in an area that regularly experiences power interruptions is also a good idea to link the system to an increase in UV suppressor. This can save having to replace UV exposure of the power system cost.
The final step in the installation of a UV system is shocking all the plumbing with household bleach. With the passage of bleach through the lines of pipes in the house the installer ensures that water that is treated by the UV system can not be contaminated by bacteria living in the hydraulic lines. The easiest way to shock the lines is to open a 5-micron filter housing, remove the filter cartridge and fill the cup with filter regular household bleach. Screw the shaft on the back of the filter housing and for each hour tap, toilet, faucet, hoses and bib at home and run until it is smell of bleach. You may need to fill in the filter cup with bleach several times. Once all lines are full of bleach water mixture is better to wait around two hours and then all lines flush with water until the bleach odor is gone. Remember to put a 5-micron filter cartridge in the housing.
Remember, even if the lamp UV is not "burnt out" after a year, has yet to be replaced. UV lamps lose intensity over time after a year and a lamp is not enough intensity to ensure that water is treated properly.
